Importing Points; Manipulation of Points; Creating Lines – worth a total of 50 points
Learning and understand the use of Points and lines within Civil 3D.
DEMONSTRATION & INSTRUCTION:
Download the following .TIF file: MS 00848-4.TIF
Open a file ASSIGNMENT2 drawing.
Create 2 points from coordinates from TIFF file.
Set Two Points; One at Station 153+30.75EC “SD” And Station 162+04.69 POT “SD”
(see MS 00848-4.PDF)
Insert TIFF file MS-00848-4 into drawing
Align TIFF file with the 2 points created
(use display order command to send TIFF file to the back)
Point Descriptions should be as follows:
Found Monument = FD 5” CONC MON; FD 0.75 IP; FD LD; FD CTRL MON
Set Monuments = SET LD; SET 2” IP; SET 1.0 IP; SET CTRL MON
Start by setting the points that are shown within the monument table.
Then continue with creating all the points within drawing.
Save Drawing and submit
0 comments